Many people are interested in learning how to replace garage door rollers. Modern Garage Doors Lexington Ky include four or five pieces that cover the whole length of the garage door opening and are connected by hinges. There is a roller mount on each hinge bracket that directs the garage door rails on each end of the garage door. Along the guide tracks, both rollers assist in raising and lowering the garage door. Today, we'll look at how to repair garage door rollers on the top and bottom of the garage door.

Disclosure: This article is provided for educational reasons only; Garage Door Repair Lexington Ky should only be performed by specialists with experience and skill in the field, such as Www.Odclex.Com.

Changing A Top Roller: A Step-By-Step Guide

Close the garage door with an automatic door opener if you have one. To allow the garage door to lift the opener's carriages, click the garage door's control button after pushing on the door's releasing handle. Then, as soon as the carriage stops moving, unhook the garage door openers electrical wire from the socket.

Then you'll want to loosen the bolt that holds the top roller mount to the door in place. A socket set can be used for this. Push the retainer bracket into place, making sure that the roller from the mount is attached.

After that, replace the roller in the bracket. Set the roller at an inclination and then simply slide the front edge of the roller into the rail. Before moving the axle into the garage door and matching the socket with the bolt on the mounting, this must be done.

Finally, reconnect the opener to its power source. To lower the carriage, push a button on the garage door's remote control. Lower the garage door until the carriage arm of the door is in contact with it. It's important to test the new roller's functionality by lifting and lowering the door immediately that it’s finished!

Changing A Bottom Roller: A Step-By-Step Guide

To begin, you'll need to raise the garage door. Remove the power cable of the opener from the socket. You must pull the rope handle in order to release the carriage.

The next step is to secure the track with a C-Clamp. The C-clamp is inserted into the track on the other side of the door from where the roller needs to be replaced.

Then, find the point where the vertical, straight track meets the 90-degree elbow segment of the track. This will be on the other side of the broken roller. The curled lip component of the straight track region beneath the crossing should be bent. A set of slip-joint pliers can cause this. This will enable you to have a sufficient width for the roller to slide out of the track.

Next, roll the door down until the roller lands in the broadest section of the bend in the channel. To lower the garage door, you need to use your hands.

After that, insert a screwdriver between the roller's beveled edge and the channel. Using the screwdriver, pull the roller out of the rail. You should pull firmly on the door's inward corner until the roller clears the track.

In addition, you'll now be able to remove the old roller from its axle mounting. Slide the replacement roller into the mounting with care. Return the door to its original place next to the track. Slip the roller back into the track with caution. The new roller should be within an elbow part of the track when you slide the garage door upwards. To help return the curved track portion to its original state, use a hammer to flatten it. Continue the cycle with the other bottom roller if necessary.