Garage door springs Lexington KY are an important part of your garage door. They help the door open and close properly. If they are not working correctly, it can cause problems with the door. Garage door springs can wear out over time, so it’s important to know when to replace them. Here are a few things you need to know about garage door springs:
Types Of Garage Door Springs
Torsion springs are located above the door, while extension springs are located along the side of the door. The type of spring you have will determine how it should be replaced or repaired if needed.
Torsion springs are considered more dangerous to work with because they can snap and cause injuries. They should only be handled by a professional if they need to be replaced. Extension springs, on the other hand, can be replaced by a homeowner without too much risk.
Each type of spring has its own benefits and drawbacks. Torsion springs are more durable and last longer than extension springs. However, they are also more expensive to install. Extension springs are less expensive but tend to break more often than torsion springs.
How To Select The Right Garage Door Springs
- Determine The Wire Size
Garage door springs come in a variety of sizes, and it is important to select the right size for your door. The wire size of the springs determines how much weight they can support. If you select springs that are too small, they will not be able to support the weight of your door, and it will eventually fall. If you select springs that are too large, they will be difficult to operate and could cause injury. To determine the wire size of your garage door springs, measure the thickness of the wire and then use this chart to find the corresponding wire size.
That will help you determine what size wires you need for the springs. Using spring wire gauge as a guide, match up the right number of strands with the required tensile strength and length. Then it's just a matter of choosing which kind of coil wire your garage needs. The most popular are straight-coil wire, spiral-wound (spring), helical wound and fabricated wire—each has its own unique look and benefits based on application needs.
- Measure The Inside Diameter
A standard garage door generally measures 7 feet, 5 inches across the bottom and 7 feet, 11 inches across the top. Measure the inside diameter of your door at these points to ensure that a spring you’re looking at will fit. Most springs are designed with maximum spring lengths of 8 to 10 inches, so if your door is wider than these measurements you may need to buy two springs or look into larger Garage door springs Lexington KY. Once you have your measurements in hand, check out these resources
- Measure The Overall Length
The overall length of the spring is its critical measurement. Because garage doors are heavy, strong springs are recommended. The safety and security of your garage will be determined by the strength of your springs. When choosing Garage door springs Lexington KY, you want to be sure that it is at least 1⁄4 shorter than the overall length of your door to ensure that it will lift the door evenly and on both sides. If the spring is too long, it can cause an uneven lift as well as an unbalanced feel while opening and closing the door; if it's too short, you risk malfunctioning hardware and potential injury to yourself or others around you.
- Check The Wind Direction
It’s important to know if your garage is exposed to the wind or not. The wind direction can cause a significant difference in the springs you need. If your garage is exposed to the north, then it’s likely to require longer springs that can take on the greater force of a strong wind. Since there are different sizes and strengths, it’s wise to check with a professional first before purchasing them yourself.
